Pressing force 2.5 tons with an operating force of approx. 330 N.
More information >The table press must always be fixed in two places.
Bend and straighten pipes up to 42 mm diameter
More information >Easy corner working without damage to inner welds
More information >Mounting in system boreholes
System 16
Pressing force 2.5 tons with an operating force of approx. 330 N.
Wide variety of accessories
Mounting in system boreholes
System 28
Pressing force 2.5 tons with an operating force of approx. 330 N.
Wide variety of accessories
The table press is used for straightening deformed steel products. With a compressive force of 2,5 tons, parts that have unwanted unevenness or tension in the material, can be straightened. With the additionally available pipe bending stamp, pipes with a diameter of up to 42 mm can be bent flexibly.
The total stroke is 60 mm, which can be achieved with 13 pump strokes with an operating force of approx. 330 N (stroke per pump stroke 4,6 mm). An overflow valve prevents additional pressure build-up when the piston rod is fully extended.
For a secure attachment on the table, the table press can be fixed through the turret head by using Fast Clamping Bolts or by the attached bolt.
With the help of the integrated bolt, the table press can be attached to the square and additionally fixed with a stop from above.
The shaped pipe former can bend or straighten pipes up to 42 mm diameter. The correct sequential process will provide a clean mark free result.
Corners can be pressed using a pre-shaped aluminum former to avoid damage to the weld seam.