Stainless Steel 28 Welding Tables Bernd Siegmund GmbH
System 28

Welding Tables

System 22

Welding Tables

System 16

Welding Tables



Rail System

Rail System

Platform System

Platform System

1. Material thickness

  • approx. 24,5 – 27 mm (stainless steel)
  • approx. 14,5 – 17 mm (stainless steel light)

2. Material

premium stainless steel X5CrNi18-10 (1.4301)

Vickers hardness grade:

Basic hardness: approx. 266 – 382

3. Data

  • Borehole spacing 100 mm
  • Grid element spacing 100 mm

  4. Table side panel

  • 200 mm high
  • additional boreholes enable parallel clamping in 50 mm grid

5. Elaborate Radiuses

  • 3 mm radius of top table edge reduces damages to Siegmund accessories and customers components
  • 6 mm radius on edges reduces risk of injury

6. System borehole

  • Ø 28,15 mm

Radius R3 for boreholes on the table surface:

(N/A with stainless steel light)

  • reduce damages to table, Siegmund accessories and customer components
  • for simple insertion of bolts and accessories
  7. Ribbing

  • spaced apart approx. 500 – 600 mm
  • raised ribbing

8. Table Legs

  • Square pipe 90x90 mm
  • Base plate Ø 90 mm (made of twisted bulk material)
  • Leg 50 mm vernier adjustment
(Data only for Leg standard equipment)

9. Bearing load

Bearing load per leg 2,000 kg.
Maximum recommended static bearing load:
with 4 legs = 4,000 kg
with 6 legs = 6,000 kg
with 8 legs = 8,000 kg
based on even load distribution.
(Data only for leg standard equipment)

Computationally resulting in substantially higher overall loads. However, the indicated bearing loads were calculated with reserves for safety reasons.

Please consult with manufacturer if higher overall loads are required.



Stainless Steel Light

For cost savings, the material thickness of the stainless steel light version was reduced from 25 mm to 15 mm. Since a bolt requires a clamping range of 50 mm, the lower material thickness can be compensated by an Adjusting Ring (Item No. 280653.N) with a thickness of 10 mm.

By equipping the welding tables with a diagonal grid the clamping options are nearly doubled.
Stainless Steel

Stainless Steel Tables are suited for work on stainless steel components, especially if very high corrosion requirements are imposed, e. g. pharmaceutical and food industry.

By equipping the welding tables with a diagonal grid the clamping options are nearly doubled.